D-Link DES-3326S - Page 305

D-Link DES-3326S Layer 3 Switch CLI Reference
show ospf ipif
Purpose Used to display the current OSPF interface
settings for the specified interface name.
Syntax
show ospf ipif {<ipif_name>}
Description This command will display the current OSPF
interface settings for the specified interface
name.
Parameters
<ipif_name> − The IP interface name for which
you want to display the current OSPF interface
settings.
Restrictions None.
DES-3326S:4#show ospf ipif ipif2
DR Address: 123.234.12.34 Backup DR Address: None
Total Entries: 1
Usage Example
To display the current OSPF interface settings, for a specific OSPF interface:
Command: show ospf ipif ipif2
Interface Name: ipif2 IP Address: 123.234.12.34|24
((Link Up)
Network Medium Type: BROADCAST Metric: 1
Area ID: 1.0.0.0 Administrative State: Enabled
Priority: 1 DR State: DR
Hello Interval: 10 Dead Interval: 40
Transmit Delay: 1 Retransmit Time:
5Authentication: None
DES-3326S:4#
299