D-Link DES-3326S - Page 306

D-Link DES-3326S Layer 3 Switch CLI Reference
show ospf all
Purpose Used to display the current OSPF settings of all
the OSPF interfaces on the Switch.
Syntax
show ospf all
Description This command will display the current OSPF
settings for all OSPF interfaces on the Switch.
Parameters None.
Restrictions None.
Usage Example:
To display the current OSPF interface settings, for all OSPF interfaces on the Switch:
DES-3326S:4#show ospf all
Command: show ospf all
Interface Name: System IP Address: 10.42.73.10|8 (Link
Up)
Network Medium Type: BROADCAST Metric: 1
Area ID: 0.0.0.0 Administrative State: Enabled
Priority: 1 DR State: DR
DR Address: 10.42.73.10 Backup DR Address: None
Hello Interval: 10 Dead Interval: 40
Authentication: None
Area ID: 1.0.0.0 Administrative State: Enabled
Transmit Delay: 1 Retransmit Time: 5
Interface Name: ipif2 IP Address: 123.234.12.34|24 ((Link Up)
Network Medium Type: BROADCAST Metric: 1
Priority: 1 DR State: DR
DR Address: 123.234.12.34 Backup DR Address: None
Hello Interval: 10 Dead Interval: 40
Transmit Delay: 1 Retransmit Time: 5
Authentication: None
Total Entries: 2
DES-3326S:4#
300