D-Link DES-3326S - Page 310

D-Link DES-3326S Layer 3 Switch CLI Reference
show ospf virtual_link
Purpose Used to display the current OSPF virtual
interface configuration.
Syntax
show ospf virtual_link {<area_id>
<neighbor_id>
Description This command will display the current
OSPF virtual interface configuration.
Parameters
<area_id> − A 32-bit number in the form of
an IP address (xxx.xxx.xxx.xxx) that
uniquely identifies the OSPF area in the
OSPF domain.
<neighbor_id> − The OSPF router ID for
the remote area. This is a 32-bit number in
the form of an IP address (xxx.xxx.xxx.xxx)
that uniquely identifies the remote area’s
Area Border Router. This is the router ID of
the neighbor router.
Restrictions None.
Usage Example:
To display the current OSPF virtual interface configuration:
DES-3326S:4#show ospf virtual_link
Transit Virtual Hello Dead Authentication Link
Area ID Neighbor Router Interval Interval Status
----------------------------------------------------------------------------------------------
10.0.0.0 20.0.0.0 10 60 None DOWN
Total Entries: 1
DES-3326S:4#
304