D-Link DES-3326S - Page 39

D-Link DES-3326S Layer 3 Switch CLI Reference
config ports
Purpose Used to configure the Switch’s Ethernet port settings.
Syntax
config ports [<portlist|all>]
{speed[auto|10_half|10_full|100_half|100_half|1000_f
ull] learning [enable|disable] state [enable|disable]}
Description This command allows for the configuration of the
Switch’s Ethernet ports. Only the ports listed in the
<portlist> will be affected.
Parameters
all − Displays all ports on the Switch.
<portlist> − Specifies a range of ports to be configured.
The port list is specified by listing the beginning port
number and the highest port number of the range. The
beginning and end of the port list range are separated by
a dash. For example, 3 would specify port 3. 4 specifies
port 4. 3-4 specifies all of the ports between port 3 and
port 4 − in numerical order.
auto − Enables auto-negotiation for the specified range
of ports.
[10/100/1000] − Configures the speed in Mbps for the
specified range of ports.
[half/full] − Configures the specified range of ports as
either full- or half-duplex.
flow_control [enable|disable] - Enables or disables the
flow control on the specified range of ports.
learning [enable|disable] − Enables or disables the MAC
address learning on the specified range of ports.
state [enable|disable] − Enables or disables the
specified range of ports.
Restrictions Only administrator-level users can issue this command.
Example Usage:
To configure the speed of port 3 to be 10 Mbps, full duplex, learning and state enabled:
DES-3326S:4#config ports 1-3 speed 10_full learning on state enable
Command: config ports 1-3 speed 10_full learning on state enable
Success.
DES-3326S:4#
33