D-Link DES-3326S - Page 40

D-Link DES-3326S Layer 3 Switch CLI Reference
show ports
Purpose Used to display the current configuration of a
range of ports.
Syntax
show ports {<portlist>}
Description This command is used to display the current
configuration of a range of ports.
Parameters
<portlist> − Specifies a range of ports to be
configured. The port list is specified by listing
the beginning port number and the highest port
number of the range. The beginning and end of
the port list range are separated by a dash. For
example, 3 would specify port 3. 4 specifies port
4. 3-4 specifies all of the ports between port 3
and port 4 − in numerical order.
Restrictions none.
Example Usage:
To display ports status:
DES-3326S:4#show ports
Command: show ports
Port Port Settings Connection Address
State Speed/Duplex/FlowCtrl Speed/Duplex/FlowCtrl Learning
------ -------- --------------------- --------------------- --------
1 Enabled Auto/Disabled Link Down Enabled
2 Enabled Auto/Disabled Link Down Enabled
3 Enabled Auto/Disabled Link Down Enabled
4 Enabled Auto/Disabled Link Down Enabled
5 Enabled Auto/Disabled Link Down Enabled
6 Enabled Auto/Disabled Link Down Enabled
7 Enabled Auto/Disabled Link Down Enabled
8 Enabled Auto/Disabled Link Down Enabled
9 Enabled Auto/Disabled Link Down Enabled
10 Enabled Auto/Disabled 100M/Full/None Enabled
11 Enabled Auto/Disabled Link Down Enabled
12 Enabled Auto/Disabled Link Down Enabled
13 Enabled Auto/Disabled Link Down Enabled
14 Enabled Auto/Disabled Link Down Enabled
15 Enabled Auto/Disabled Link Down Enabled
16 Enabled Auto/Disabled Link Down Enabled
17 Enabled Auto/Disabled 100M/Full/None Enabled
18 Enabled Auto/Disabled Link Down Enabled
19 Enabled Auto/Disabled Link Down Enabled
20 Enabled Auto/Disabled Link Down Enabled
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
34