D-Link DES-3326S - Page 91

D-Link DES-3326S Layer 3 Switch CLI Reference
create syslog host
Purpose Used to create a new syslog host.
Syntax
config syslog host [all|<index 1-4>] {severity [informational|warning|all]|
facility[local0|local1|local2|local3|
local4|local5|local6|local7]|udp_port<int>| ipaddress <ipaddr>|
state[enable|disable]
Description
The create syslog host command is used to create a new syslog host.
Parameters
all − Specifies that the command will be applied to all hosts.
<index 1-4> − Specifies that the command will be applied to an index of hosts.
There are four available indexes, numbered 1 through 4.
severity − Severity level indicator. These are described in the following:
Bold font indicates that the corresponding severity level is currently supported
on the Switch.
Numerical Severity
Code
0 Emergency: system is unusable
1 Alert: action must be taken immediately
2 Critical: critical conditions
3 Error: error conditions
4 Warning: warning conditions
5 Notice: normal but significant condition
6 Informational: informational messages
7 Debug: debug-level messages
informational − Specifies that informational messages will be sent to the
remote host. This corresponds to number 6 from the list above.
warning − Specifies that warning messages will be sent to the remote host.
This corresponds to number 4 from the list above.
all − Specifies that all of the currently supported syslog messages that are
generated by the Switch will be sent to the remote host.
facility − Some of the operating system daemons and processes have been
assigned Facility values. Processes and daemons that have not been
explicitly assigned a Facility may use any of the"local use" facilities or they
may use the "user-level" Facility. Those Facilities that have been designated
are shown in the following: Bold font indicates the facility values that the
Switch currently supports.
85