D-Link DFE-2600 - Product Features

Dual-Speed Stackable Hubs User’s Guide
Introduction2
In the basic configuration, the 10Mbps and 100Mbps segments are separate
and do not intercommunicate. An optional DFE-260S switch module (in-
cluded with the DFE-2616x, DFE-2624x, DFE-2616ix, and DFE-2624ix) can
be installed in any hub in the stack, making it possible to transparently bridge
between the 10Mbps and 100Mbps segments. In a managed hub stack, more
than one DFE-260S module can be used to provide redundancy if the two
modules are both in the primary master hub segment..
Other add-in modules are also available, providing 100BASE-TX, or
100BASE-FX connections. DFE-2600 series hubs each have two slots for
accepting slide-in modules.
Product Features
The list below highlights the features and specifications of the DFE-2600
series hubs.
♦
Compatible with the IEEE 802.3 10BASE-T Ethernet and 802.3u
100BASE-TX Fast Ethernet industry standards for interoperability
with other Ethernet/Fast Ethernet network devices.
♦
Ethernet connections support Category 3 or better twisted-pair cables.
♦
Fast Ethernet connections support both shielded twisted pair and
Category 5 unshielded twisted-pair cables.
♦
Fast Ethernet connections support a maximum distance of 100 meters
from end-station to hub, and a total network diameter of 205 meters.
♦
Sixteen (DFE-2616, DFE-2616x, DFE-2616i, DFE-2616ix) or twenty-
four (DFE-2624, DFE-2624x, DFE-2624i, DFE-2624ix) NWay RJ-45
ports for connecting stations to the network.
♦
Auto negotiated connection speed (NWay) on each port.