Master Hub Setup and Management 49
♦ Boot Server IP Address
. This variable is the IP address of the TFTP
server where the configuration file is located. This entry is used only if
the
S/W Update Control
is enabled and your boot protocol is TFTP
only; if you are using BOOTP&TFTP mode, or if
Send BOOTP Re-
quest on Power Up
is enabled, the address will be obtained from the
BOOTP server.
♦ Boot File Name
. The pathname of the configuration file on your
TFTP server. If you are using D-View as your TFTP server, this is
the pathname of the .CFG file on your hard disk. This entry is used
only if your boot protocol is TFTP ONLY; if you are using
BOOTP&TFTP mode, or if
Use BOOTP to get IP after start up
is en-
abled, the pathname will be obtained from the BOOTP server. For
more information about the DFE-2600 series master hub configuration
file, see
Appendix C,
Boot Configuration File.
DFE-2600 Stackable Hub - Software Update Menu
Software Update <Disable>
Software Update Mode <Network >
Boot Protocol <TFTP ONLY >
Boot Server IP Address [210.68.85.36 ]
Boot File Name [c:\dfe2600i.cfg ]
Last Boot Server IP Address: 210.68.85.35
HELP SAVE EXIT
SNMP Information
The System Configuration Menu screen shows a variety of information about
your hub, and allows you to set the System Name, System Location, and
System Contact. These settings can be retrieved from the hub using SNMP
To Next Page
Loading...
Need help?
General
