Web-Based Network Management 89
♦ Administration State
Indicates the port partition status, either
en-
abled
or
disabled
.
Reset
Doing a remote reset is equivalent to turning the hub off and on again. All
parameters are returned to the values stored in EEPROM.
Click
RESET
to reset the Hub.
User
The User menu allows you to monitor and configure a number of settings for
individual ports.
User List
Clicking on the User List option on the left side of the screen displays a rep-
resentation of your hub stack. Clicking on one of the ports displays the
Ethernet (MAC) addresses of packets recently received by the port and when
they were received, as shown below.
To Next Page
Loading...
Need help?
General
