D-Link DGS-3120-24PC - Page 119

xStack
®
DGS-3120 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
115
Parameters
profile_id - (Optional) Specify the index of the egress access list profile.
<value 1-4> - Enter the profile ID here. This value must be between 1 and 4. A lower value
denotes a higher priority.
profile_name - (Optional) Specify the name of the profile. The maximum length is 32 characters.
<name 1-32> - Enter the profile name here. This name can be up to 32 characters long.
If no parameter is specified, will show the all egress access profile.
Restrictions
None.
Example
To display current egress access list table:
DGS-3120-24TC:admin#show egress_access_profile
Command: show egress_access_profile
Egress Access Profile Table
Total User Set Rule Entries : 3
Total Used HW Entries : 4
Total Available HW Entries : 508
================================================================================
Profile ID: 1 Profile name: EthernetACL Type: Ethernet
MASK on
VLAN : 0xFFF
802.1p
Available HW Entries : 127
--------------------------------------------------------------------------------
Rule ID : 1 (auto assign) Ports: 1:1
Match on
802.1p : 0
Action:
Permit
================================================================================
================================================================================
Profile ID: 2 Profile name: IPv4 Type: IPv4
MASK on
DSCP
ICMP
Available HW Entries : 127