D-Link DGS-3120-24PC - 39-13 Disable Jwac Quarantine_Server_Monitor

xStack
®
DGS-3120 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
397
39-13 disable jwac quarantine_server_monitor
Description
This command is used to disable JWAC quarantine server monitoring.
Format
disable jwac quarantine_server_monitor
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To disable JWAC quarantine server monitoring:
DGS-3120-24TC:admin#disable jwac quarantine_server_monitor
Command: disable jwac quarantine_server_monitor
Success.
DGS-3120-24TC:admin#
39-14 config jwac quarantine_server_error_timeout
Description
This command is used to set the quarantine server error timeout. When the quarantine server
monitor is enabled, the JWAC switch will periodically check if the quarantine works okay. If the
Switch does not receive any response from quarantine server during the configured error timeout,
the Switch then regards it as not working properly.
Format
config jwac quarantine_server_error_timeout <sec 5-300>
Parameters
<sec 5-300> - Specify the error timeout interval.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.