D-Link DGS-3120-24PC - Chapter 82 Telnet Client Command List

xStack
®
DGS-3120 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
739
Chapter 82 Telnet Client Command List
telnet [<ipaddr> | <ipv6addr>] {tcp_port <value 1-65535>}
82-1 telnet
Description
This command is used to start the telnet client to connect to the specific telnet server. The
parameters specified by the command will only be used for the establishment of this specific
session. They will not affect the establishment of other sessions.
Format
telnet [<ipaddr> | <ipv6addr>] {tcp_port <value 1-65535>}
Parameters
<ipaddr> - The IP address of the telnet server.
<ipv6addr> - The IPv6 address of the telnet server. (EI Mode Only)
tcp_port - (Optional) Specify the telnet server port number to be connected. If not specified, the
default port is 23.
<value 1-65535> - Enter the TCP port number used here. This value must be between 1 and
65535.
Restrictions
None.
Example
Telnet to a Switch by specifying the IP address:
DGS-3120-24TC:admin# telnet 10.90.90.90
Command: telnet 10.90.90.90
DGS-XXXX Fast Ethernet Switch Command Line Interface
Firmware: Build 1.00.B01
Copyright(C) 2006-2009 D-Link Corporation. All rights reserved.
UserName: