D-Link DGS-3120-24PC - 255> | Retransmit <Int

xStack
®
DGS-3120 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
79
Restrictions
Only Administrator-level users can issue this command.
Example
To display all authentication server groups:
DGS-3120-24TC:admin# show authen server_group
Command: show authen server_group
Group Name IP Address Protocol
--------------- --------------- --------
mix_1 10.1.1.222 TACACS+
10.1.1.223 TACACS
radius 10.1.1.224 RADIUS
tacacs 10.1.1.225 TACACS
tacacs+ 10.1.1.226 TACACS+
xtacacs 10.1.1.227 XTACACS
Total Entries : 5
DGS-3120-24TC:admin#
5-22 create authen server_host
Description
This command is used to create an authentication server host. When an authentication server host
is created, IP address and protocol are the index. That means over 1 authentication protocol
services can be run on the same physical host. The maximum supported number of server hosts is
16.
Format
create authen server_host <ipaddr> protocol [tacacs | xtacacs | tacacs+| radius] {port <int
1-65535> | [key [<key_string 254> | none] | encryption_key <key_string 344> ]| timeout <int
1-255> | retransmit <int 1-20>}
Parameters
<ipaddr> - Enter the server host IP address.
protocol - Specify the host's authentication protocol.
tacacs - Server host’s authentication protocol.
xtacacs - Server host’s authentication protocol.
tacacs+ - Server host’s authentication protocol.
radius - Server host’s authentication protocol.
port - (Optional) The port number of authentication protocol for server host. Default value for
TACACS/XTACACS/TACACS+ is 49. Default value for RADIUS is 1812.
<int 1-65535> - Enter the authentication protocol port number here. This value must be
between 1 and 65535.
key - (Optional) The key for TACACS+ and RADIUS authentication. If the value is null, no