D-Link DGS-3120-24PC - Chapter 22 Debug Software Command List

xStack
®
DGS-3120 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
225
Chapter 22 Debug Software Command
List
debug error_log [dump | clear | upload_toTFTP <ipaddr> <path_filename 64>]
debug show error_reboot state
debug buffer [utilization | dump | clear | upload_toTFTP <ipaddr> <path_filename 64>]
debug output [module <module_list> | all] [buffer | console]
debug config error_reboot [enable | disable]
debug config state [enable | disable]
debug clear cpu port counter [<portlist> | all]
debug show cpu port counter [<portlist> | all] [by_cos | by_reason | by_protocol [L2 | ARP | IPv4
[ICMP | TCP | UDP | multicast-protocol | unicast-protocol | all] | IPv6 [ICMP | TCP | UDP |
OSPFV3 | all] | STACK] | by_priority]
debug show jwac auth_info
debug show status {module <module_list>}
debug dhcpv6_client state enable (EI Mode Only)
debug dhcpv6_client state disable (EI Mode Only)
debug dhcpv6_client output [buffer | console] (EI Mode Only)
debug dhcpv6_client packet [all | receiving | sending] state [enable | disable] (EI Mode Only)
debug dhcpv6_relay state enable (EI Mode Only)
debug dhcpv6_relay state disable (EI Mode Only)
debug dhcpv6_relay output [buffer | console] (EI Mode Only)
debug dhcpv6_relay packet [all | receiving | sending] state [enable | disable] (EI Mode Only)
debug dhcpv6_relay hop_count state [enable | disable] (EI Mode Only)
22-1 debug error_log
Description
This command is used to dump, clear or upload the software error log to a TFTP server.
Format
debug error_log [dump | clear | upload_toTFTP <ipaddr> <path_filename 64>]
Parameters
dump - Display the debug message of the debug log.
clear - Clear the debug log.
upload_toTFTP - Upload the debug log to a TFTP server specified by IP address.
<ipaddr> - Specify the IPv4 address of the TFTP server.
<path_filename 64> - The pathname specifies the DOS pathname on the TFTP server. It can
be a relative pathname or an absolute pathname. This value can be up to 64 characters
long.
Restrictions
Only Administrator-level users can issue this command.