D-Link DGS-3120-24PC - Show Switch

xStack
®
DGS-3120 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
141
12-5 show switch
Description
This command is used to display the Switch information.
Format
show switch
Parameters
None.
Restrictions
None.
Example
The following is an example for display of the Switch information.
DGS-3120-24TC:admin#show switch
Command: show switch
Device Type : DGS-3120-24TC Gigabit Ethernet Switch
Unit ID : 1
MAC Address : 00-00-00-01-02-03
IP Address : 10.90.90.90 (Manual)
VLAN Name : default
Subnet Mask : 255.0.0.0
Default Gateway : 0.0.0.0
Boot PROM Version : Build 2.00.003
Firmware Version : Build 2.50.015
Hardware Version : A2
Firmware Type : EI
Serial Number : PVT51B3000001
System Name :
System Location :
System Uptime : 0 days, 0 hours, 23 minutes, 23 seconds
System Contact :
Spanning Tree : Disabled
GVRP : Disabled
IGMP Snooping : Disabled
MLD Snooping : Disabled
VLAN Trunk : Disabled
Telnet : Enabled (TCP 23)
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All