D-Link DGS-3120-24PC - Show Scheduling

xStack
®
DGS-3120 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
604
65-6 config scheduling_mechanism
Description
This command is used to configure the traffic scheduling mechanism for each CoS queue.
Format
config scheduling_mechanism {ports [<portlist> | all]} [strict | wrr]
Parameters
ports - (Optional) Specify a range of ports to be configured.
<portlist> - Enter the list of port used for this configuration here.
all - For set all ports in the system, you may use “all” parameter. If no parameter is specified,
system will set all ports.
strict - All queues operate in strict mode.
wrr - Each queue operates based on its setting.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the traffic scheduling mechanism for each CoS queue:
DGS-3120-24TC:admin# config scheduling_mechanism strict
Command: config scheduling_mechanism strict
Success.
DGS-3120-24TC:admin#
To configure the traffic scheduling mechanism for CoS queue on port 1:1:
DGS-3120-24TC:admin# config scheduling_mechanism ports 1:1 strict
Command: config scheduling_mechanism ports 1:1 strict
Success.
DGS-3120-24TC:admin#
65-7 show scheduling
Description
This command is used to display the current traffic scheduling parameters.
Format
show scheduling {<portlist>}