xStack
®
DGS-3120 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
150
Parameters
ipif_name - Specify the name of the IP interface.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
all – Specify that all the IP interfaces will be enabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable an IP interface:
DGS-3120-24TC:admin#enable ipif newone
Command: enable ipif newone
Success.
12-17 disable ipif (EI Mode Only)
Description
This command is used to disable an IP interface.
Format
disable ipif [<ipif_name 12> | all]
Parameters
ipif_name - Specify the name of the IP interface.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
all – Specify that all the IP interfaces will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To disable an IP interface:
DGS-3120-24TC:admin#disable ipif newone
Command: disable ipif newone
Success.
To Next Page
Loading...
