D-Link DGS-3120-24PC - Page 238

xStack
®
DGS-3120 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
234
DGS-3120-24TC:admin#debug show status
Command: debug show status
Debug Global State : Enabled
MSTP : Disabled
IMPB : Disabled
DHCPv6_CLIENT : Disabled
DHCPv6_RELAY : Disabled
ERPS : Disabled
DGS-3120-24TC:admin#
22-11 debug dhcpv6_client state enable (EI Mode Only)
Description
This command is used to enable the DHCPv6 client debug function.
Format
debug dhcpv6_client state enable
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.
Example
To enabled the DHCPv6 client debug function:
DGS-3120-24TC:admin#debug dhcpv6_client state enable
Command: debug dhcpv6_client state enable
Success.
DGS-3120-24TC:admin#
22-12 debug dhcpv6_client state disable (EI Mode Only)
Description
This command is used to disable the DHCPv6 client debug function.
Format
debug dhcpv6_client state disable