EasyManua.ls Logo

D-Link DGS-3120-24PC - Page 266

D-Link DGS-3120-24PC
852 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
xStack
®
DGS-3120 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
262
<portlist> - Enter the list of ports to be configured here.
all - Specify that all the port will be used for this configuration.
delete permit - Specify to delete a DHCP permit.
server_ip - The IP address of the DHCP server to be filtered.
<ipaddr> - Enter the DHCP server IP address here.
client_mac - (Optional) The MAC address of the DHCP client.
<macaddr> - Enter the DHCP client MAC address here.
ports - The port number of filter DHCP server.
<portlist> - Enter the list of ports to be configured here.
all - Specify that all the port will be used for this configuration.
state - Specify to enable or disable the filter DHCP server state.
enable - Specify that the filter DHCP server state will be enabled.
disable - Specify that the filter DHCP server state will be disabled.
illegal_server_log_suppress_duration - Specify the same illegal DHCP server IP address
detected will be logged only once within the duration. The default value is 5 minutes.
1min - Specify that illegal server log suppress duration value will be set to 1 minute.
5min - Specify that illegal server log suppress duration value will be set to 5 minutes.
30min - Specify that illegal server log suppress duration value will be set to 30 minutes.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To add an entry from the DHCP server/client filter list in the Switch’s database:
DGS-3120-24TC:admin# config filter dhcp_server add permit server_ip 10.1.1.1
client_mac 00-00-00-00-00-01 port 1:1-1:24
Command: config filter dhcp_server add permit server_ip 10.1.1.1 client_mac 00-
00-00-00-00-01 port 1:1-1:24
Success.
DGS-3120-24TC:admin#
DGS-3120-24TC:admin# config filter dhcp_server ports 1:1-1:10 state enable
Command: config filter dhcp_server ports 1:1-1:10 state enable
Success.
DGS-3120-24TC:admin#
25-2 show filter dhcp_server
Description
This command is used to display the DHCP server/client filter list created on the Switch.
Format
show filter dhcp_server

Table of Contents

Other manuals for D-Link DGS-3120-24PC

Related product manuals