D-Link DGS-3120-24PC - Page 326

xStack
®
DGS-3120 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
322
show igmp_snooping forwarding {[vlan <vlan_name 32> | vlanid <vlanid_list>]}
show router_ports [vlan <vlan_name 32> | vlanid <vlanid_list> | all ] {[static | dynamic |
forbidden]}
show igmp_snooping statistic counter [vlan <vlan_name> | vlanid <vlanid_list> | ports
<portlist>]
show igmp access_authentication ports [all | <portlist>]
clear igmp_snooping statistics counter
config mld_snooping [vlan_name <vlan_name 32> | vlanid <vlanid_list> |all] {state [enable |
disable] | fast_done [enable | disable] | proxy_reporting {state [enable | disable] | source_ip
<ipv6addr>}(1)}(1)
config mld_snooping querier [vlan_name <vlan_name 32> | vlanid <vlanid_list> | all]
{query_interval <sec 1-65535> | max_response_time <sec 1-25> | robustness_variable
<value 1-7> | last_listener_query_interval <sec 1-25> | state [enable | disable] | version
<value 1-2>}(1)
config mld_snooping mrouter_ports [vlan <vlan_name 32> | vlanid <vlanid_list>] [add | delete]
<portlist>
config mld_snooping mrouter_ports_forbidden [vlan <vlan_name 32> | vlanid <vlanid_list>]
[add | delete] <portlist>
enable mld_snooping
disable mld_snooping
show mld_snooping {[vlan <vlan_name 32> | vlanid <vlanid_list>]}
show mld_snooping group {[vlan <vlan_name 32> | vlanid <vlanid_list> | ports <portlist>]
{<ipv6addr>}} {data_driven}
show mld_snooping forwarding {[vlan <vlan_name 32> | vlanid <vlanid_list>]}
show mld_snooping mrouter_ports [vlan <vlan_name 32> | vlanid <vlanid_list> | all] {[static |
dynamic | forbidden]}
create mld_snooping static_group [vlan <vlan_name 32> | vlanid <vlanid_list>] <ipv6addr>
delete mld_snooping static_group [vlan <vlan_name 32> | vlanid <vlanid_list>] <ipv6addr>
config mld_snooping static_group [vlan <vlan_name 32> | vlanid <vlanid_list>] <ipv6addr> [add
| delete] <portlist>
show mld_snooping static_group {[vlan <vlan_name 32> | vlanid <vlanid_list>] <ipv6addr>}
config mld_snooping data_driven_learning [all | vlan_name <vlan_name 32> | vlanid
<vlanid_list>] { state [enable | disable] | aged_out [enable | disable ] | expiry_time <sec 1-
65535>}(1)
config mld_snooping data_driven_learning max_learned_entry <value 1-1024>
clear mld_snooping data_driven_group [all | [vlan_name <vlan_name 32> | vlanid <vlanid_list>]
[<ipv6addr>| all]]
show mld_snooping statistic counter [vlan <vlan_name> | vlanid <vlanid_list> | ports <portlist>]
clear mld_snooping statistics counter
config mld_snooping rate_limit [ports <portlist> | vlanid <vlanid_list>] [<value 1-1000> | no_limit]
show mld_snooping rate_limit [ports <portlist> | vlanid <vlanid_list>]
35-1 config igmp_snooping
Description
This command is used to configure IGMP snooping on the Switch.
Format
config igmp_snooping [vlan_name <vlan_name 32> | vlanid <vlanid_list> | all ] { state
[enable | disable] | fast_leave [enable | disable] | proxy_reporting {state [enable|disable] |
source_ip <ipaddr>}(1)}(1)