xStack
®
DGS-3120 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
797
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure WAC auth method:
DGS-3120-24TC:admin# config wac method radius
Command: config wac method radius
Success.
93-5 config wac default_redirpath
Description
This command is used to configure WAC default redirect path. If default redirect path is configured,
the user will be redirected to the default redirect path after successful authentication.
When the string is cleared, the client will not be redirected to another URL after successful
authentication.
Format
config wac default_redirpath <string 128>
Parameters
<string 128> - The URL that the client will be redirected to after successful authentication. By
default, the redirected path is cleared. This value can be up to 128 characters long.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To config WAC default redirect URL:
DGS-3120-24TC:admin# config wac default_redirpath http://www.dlink.com
Command: config wac default_redirpath http://www.dlink.com
Success.
To Next Page
Loading...
