D-Link DGS-3120-24PC - Page 9

xStack
®
DGS-3120 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
5
Command: show
Next possible completions:
802.1p 802.1x access_profile account
accounting acct_client address_binding
arp_spoofing_prevention arpentry asymmetric_vlan
attack_log auth_client auth_diagnostics
auth_session_statistics auth_statistics authen
authen_enable authen_login authen_policy authentication
authorization autoconfig backup bandwidth_control
boot_file bpdu_protection cfm command
command_history community_encryption config
cpu cpu_filter current_config ddm
device_status dhcp_local_relay dhcp_relay dhcpv6_relay
dlms dot1v_protocol_group dscp
duld egress_access_profile egress_flow_meter
environment erps error ethernet_oam
execute_config fdb filter flow_meter
gratuitous_arp greeting_message gvrp hol_prevention
igmp igmp_snooping ipfdb ipif
ipif_ipv6_link_local_auto iproute ipv6
ipv6route jumbo_frame jwac l2protocol_tunnel
lacp_port led limited_multicast_addr
link_aggregation lldp lldp_med log
log_save_timing log_software_module loopdetect
mac_based_access_control mac_based_access_control_local
mac_based_vlan mac_notification max_mcast_group
mcast_filter_profile mirror mld_snooping
multicast multicast_fdb nlb packet
password_recovery per_queue poe port
port_group port_security port_security_entry
port_vlan ports power_saving pppoe
private_vlan pvid qinq radius
rmon route router_ports rspan
safeguard_engine scheduling scheduling_mechanism
serial_port session sflow sim
smtp snmp sntp ssh
ssl stack_device stack_information stacking_mode
storage_media_info stp surveillance_vlan
switch syslog system_severity tech_support
terminal time time_range traffic
traffic_segmentation trap trusted_host
udp_helper utilization vlan vlan_translation
vlan_trunk voice_vlan wac wred
DGS-3120-24TC:admin#
In the above example, all of the possible next parameters for the show command are displayed. At
the next command prompt, the up arrow was used to re-enter the show command, followed by the
account parameter. The CLI then displays the user accounts configured on the Switch.