Print Server Setup 33
♦ TCP/IP
UNIX lpr/lpd (HP-UX, SunOS, Solaris, SCO, UnixWare, IBM
AIX); Windows NT
♦ NetBEUI
Windows NT, Windows 95/98, Windows for Workgroups, Micro-
soft LAN Manager, IBM LAN Server
♦ AppleTalk
MacOS EtherTalk
The print server configuration, features, and operation can all be
controlled using the same Telnet or browser interface as the WAN
port and other aspects of the internet/print server (see the next chap-
ter).
Connecting the Print Server
To connect your printer to the internet/print server, you should use
the standard parallel cable that comes with the printer. If you need
to purchase a new parallel cable, be certain that the connectors on
both ends of the cable are the right type and that the total cable
length does not exceed 12 feet (approximately 4 meters).
Follow these steps for a trouble-free print-server connection.
1. Confirm proper operation of the printer to be connected to the
internet/print server.
2. When you have confirmed proper operation of the printer,
switch its power off.
To Next Page
Loading...
Need help?
General
