D-Link DSL-2745 - Page 35

30D-Link DSL-2745 Wireless N300 ADSL2+ Modem Router User Manual
Section 4 - Conguration
User Name: Enter your DSL account username provided by your ISP.
Password: Enter your DSL account password provided by your ISP.
Type: Select how your DSL-2745 connects to your ISP. Choose either
Continuous, Connect on Demand, and Manual.
Idle Time (min): If you selected Connect on Demand, enter the amount time the
router waits if there is no activity before disconnecting.
WAN IP Settings: If IPv4 or IPv4/IPv6 is selected, these settings are disabled. The
router will use DHCP only, Fixed (Static IP) is unavailable.
IPv6 WAN
Settings:
Configure the IPv6 WAN settings. If the IP Protocol is set to IPv4,
these settings are unavailable.
Address Mode: Select either Slaac or Static.
IPv6 Address: Enter your IPv6 Static Address. Only available in Static mode.
IPv6 Gateway: Enter your IPv6 Gateway. Only available in Static mode.
DHCPv6 Mode: Select either Auto, Enable, or Disable.
Request DHCPv6
Address:
Check this box to enable. Only available if DHCPv6 Mode is set to
Enable or Auto:
Request DHCPv6
PD:
Check this box to enable. Only available if DHCPv6 Mode is set to
Enable.
Click Add to create your connection.
PPPoE Mode (continued)