D-Link DSL-2745 - Ipv6;Port Filter

82D-Link DSL-2745 Wireless N300 ADSL2+ Modem Router User Manual
Section 4 - Conguration
IPv6/Port Filter
The IPv6/Port lter is used to restrict or allow certain types of IPv6 data packets
through the gateway. These lters are helpful in securing or restricting trac
on your local network.
Outgoing Default
Action:
Select whether to Permit or Deny data packets to ow out of the
WAN interface. The default setting is Permit.
Incoming Default
Action:
Select whether to Permit or Deny data packets to ow into the WAN
interface. The default setting is Permit.
DEFAULT ACTION STATUS
Rule Action: Select whether this rule will Permit or Deny data packets.
Protocol: Select the protocol type: IPv6, ICMP6, TCP, or UDP.
Icmp6Type: If ICMP6 is selected, select Ping6.
Direction: Select the direction, either Upstream or Downstream.
Source IP Address
& Prefix Length:
Enter the source IPv6 address and prex length for the rule.
Destination IP
Address & Prefix
Length:
Enter the destination IP address and subnet mask for the rule.
SPort: Enter the source port number if TCP or UDP is selected.
DPort: Enter the destination port number if TCP or UDP is selected.
RULE CONFIGURATION
To create a rule, ll out the following parameters.