D-Link DSR-150 - Client Routes

D-Link DSR-Series User Manual 135
Section 7 - VPN
Client Routes
Path: VPN > SSL VPN > Client Routes
If the SSL VPN client is assigned an IP address in a dierent subnet than the corporate network, a client route
must be added to allow access to the private LAN through the VPN tunnel. As well a static route on the private
LAN‘s rewall (typically this router) is needed to forward private trac through the VPN Firewall to the remote
SSL VPN client.
When split tunnel mode is enabled, the user is required to congure routes for VPN tunnel clients:
• Destination network: The network address of the LAN or the subnet information of the
destination network from the VPN tunnel clients‘ perspective is set here.
• Subnet mask: The subnet information of the destination network is set here.
To congure a client route:
1. Click VPN > SSL VPN > Client Routes.
2. Click Add New Client Route.
3. Enter the destination network and subnet mask.
4. Click Save.