D-Link DSR-150 - IGMP Setup

D-Link DSR-Series User Manual 24
Section 4 - LAN Conguration
IGMP Setup
Path: Network > LAN > IGMP Setup
IGMP snooping (IGMP Proxy) allows the router to ‘listen’ in on IGMP network trac through the router. This then
allows the router to lter multicast trac and direct it only to hosts that need this stream. This is helpful when
there is a lot of multicast trac on the network where all LAN hosts do not need to receive this multicast trac.
To enable IGMP Proxy:
1. Click Network > LAN > IGMP Setup.
2. Toggle IGMP Proxy to On.
3. Click Save.
1. The IGMP proxy is switched on.
2. Click IGMP Snooping tab.
3. Toggle IGMP Snooping to On and click Save.
4. Right click to edit any of the VLAN IDs.
Note: IGMP Snooping is supported only in DSR-250/250N.
To enable IGMP Snooping: