D-Link DWC-2000 - Basic Configuration Procedures

22
setup
configuration.
23
show net radvd
.
24
show net radvd setup
Display RADVD
configuration.
25
show net routing dynamic
Show dynamic routing
setup.
26
show net routing dynamic setup
Show dynamic routing
Setup.
27
show net routing
Displays routing setup.
28
show net routing static
.
29
show net routing static ipv4
.
30
show net routing static ipv4
setup
Show all the configured
IPV4 routes.
31
show net routing static ipv6
.
32
show net routing static ipv6
setup
Show all the configured
IPV6 routes.
33
show net captivePortal
34
show net captivePortal
billing_profile <row_id>
35
show net captivePortal
all_billing_profile
36
show net vlan
37
show net vlan configuration
38
show net multivlan
show vlan server status.
39
show net multivlan subnet
show vlan server status.
40
show net multivlan subnet
status
Display vlan server
status.
41
show net port-vlan
show Port vlan status.
42
show net port-vlan status
Display Port vlan status.
The command “wlan ?” at the CLI prompt, gives a description of all the
configuration commands in the branch wlan , these are as follows:
1
wlan ap_management
AP Management.
2
wlan ap_management manual
Request
administrative
commands/actions
for managed
access points.
3
wlan ap_management ap_database
Enter AP Database
configuration mode.
4
wlan ap_management
rf_management
Configure power
plan and channel