D-Link DWC-2000 - Page 23

21
1
show security
advanced_network
show advanced firewall
attack checks.
2
show security
advanced_network igmp
Display igmp configuration.
The command “show ldap-serverCheck ?” at the CLI prompt, gives a
description of all the show commands in the branch ldap-serverCheck , these
are as follows:
1
show ldap-serverCheck
Display status of Ldap servers.
The command “show net ?” at the CLI prompt, gives a description of all the
show commands in the branch net , these are as follows:
1
show net bandwidth
.
2
show net bandwidth profile
.
3
show net bandwidth profile
setup
Show list of Available
Bandwidth Profile(s).
4
show net bandwidth
traffic_selector
.
5
show net bandwidth
traffic_selector setup
Show list of Available
Traffic Selector(s).
6
show net lan dhcp
.
7
show net lan dhcp reserved_ip
.
8
show net lan dhcp reserved_ip
setup
Show list of DHCP
Reserved Addresses.
9
show net lan dhcp
leased_clients
.
10
show net lan dhcp
leased_clients list
Show list of Available
DHCP Leased Clients.
11
show net ethernet
Show Ethernet interfaces.
12
show net lan
.
13
show net lan ipv4
.
14
show net lan ipv4 setup
Show LAN Configuration.
15
show net lan ipv6
.
16
show net lan ipv6 setup
Show LAN Configuration.
17
show net statistics <interface>
Show Interface Statistics.
18
show net mode
.
19
show net mode setup
Display IP MODE
configuration.
20
show net port
.
21
show net port management
.
22
show net port management
Display port management