D-Link DWC-2000 - Page 31

29
56
system group access_control_ip
add
Add an ip to Access
Control ips list.
57
system group access_control_ip
delete <row_id>
Delete an ip from
Access Control ips list.
The command “util ?” at the CLI prompt, gives a description of all the
configuration commands in the branch util , these are as follows:
1
util restore-factory-defaults
Revert to
factory
default
settings.
2
util system_check
System check
options.
3
util system_check ping <ip_address>
Ping an
Internet
Address.
4
util system_check dns_lookup <dns>
To retrieve
the IP
address of a
Web, FTP,
Mail or any
other Server
on the
Internet.
5
util system_check traceroute <ip_address>
Display all the
routers
present
between the
destination IP
address and
this router.
6
util system_check
display_IPV4_routingtable
Display IPV4
Routing
Table.
7
util system_check capturePackets
Allows you to
capture all
packets that
pass through
the selected
interface.
8
util system_check capturePackets
start <interface>
Start the
packet
capture.
9
util system_check capturePackets
Display