D-Link DWM-312W

48D-Link DWM-312W User Manual
Section 4 - Conguration
IPsec/Adding
General Settings
Dynamic IPsec Toggle this switch to enable Dynamic IPsec.
Type Select between Address and FQDN.
Remote host Enter the IP address of the remote host. If Dynamic
IPsec is enabled, this eld will be disabled.
Identier value Specify the local identier value.
Pre-shared key Specify a pre-shared key.
Local WAN Specify the WAN from the drop-down list.
NAT Traversal Specify either Disabled, Enabled or Force.
Type Specify the IPsec mode of operation (either TUNNEL
or TRANSPORT).