D-Link DWM-312W

88D-Link DWM-312W User Manual
Section 4 - Conguration
Routing
Add route
Enable Toggle this to enable the routing feature.
Protocol Choose the protocol used by the static route.
Interface Choose the interface used by the static route.
Destination
network
Specify the IP address of the destination.
Destination
netmask
Specify the netmask used by the destination IP.
Gateway Specify the gateway used by the static route.
Metric Specify a metric between 1 and 255.
Table Specify the table which the route should belong to.
On this page, you can congure the routing feature and add new routes.