D-Link mydlink DNR-202L

49D-Link DNR-202L User Manual
Section 5: Conguration
Select this connection if you have a DHCP server running on your
network and would like a dynamic IP address to be automatically
updated to your NVR.
You may obtain a static or xed IP address and other network information
from your network administrator for your NVR. A Static IP address will
simplify access to your NVR in the future.
The Static IP address.
The default value 255.255.255.0 is used to determine if the destination
is in the same subnet.
The Gateway forwards frames to destinations in a dierent subnet.
Invalid gateway settings may cause the failure of transmissions to a
dierent subnet.
Primary domain name server that translates names to IP addresses.
Secondary domain name server to backup the primary one.
Check to enable the DHCP server. If your network doesn’t have DHCP
server, enable NVR DHCP server for easier local network setup.
Enter the DHCP IP Address Range.
Enter the DHCP Lease Time in hours.
Network Setup
DHCP:
Static IP:
IP Address:
Subnet Mask:
Gateway:
DNS1:
DNS2:
Enable DHCP
server:
DHCP IP
Address Range:
DHCP Lease
Time: