6
-8
DK35SE/DK40(C)SE/DK45(C)SE
6. Start the engine and drive backward
toward the implement. Then, the
lower link end is inserted to its origi-
nal position.
(1) Lower Link End
H11O569A
7. Separate the top link from its
bracket and turn it to adjust its
length so that it becomes close to
the upper bracket mounting hole of
the implement. Then, fit it to the
mounting hole, insert the lock pins,
and fix it with the snap pin. Remove
the implement support as nece-
ssary.
(1) Top Link (3) Snap Pin
(2) Lock pin
H11O561A
8.Turn the top link to make the imple-
ment balanced. Then, move the
implement to the left and right, and
secure it into the proper position by
fitting the telescopic stabilizers lock
pin
9. Connect the universal joint to the
PTO shaft if necessary. At this time,
stop the engine, lower the imple-
ment onto the ground, and set the
PTO gear neutral.
(1) Telescopic Stabilizers Pin
H11O563A
To Next Page