Daedong KIOTI EX45 - Adjustment of Stabilizer; Draft Hitch and Trailer

6
-
7
6
-
6
3-POINT HITCH IMPLEMENT OPERATIONEX35(C)/EX40(C)/EX45(C)/EX50(C)
6
6
-
7
6
-
6
3-POINT HITCH IMPLEMENT OPERATIONEX35(C)/EX40(C)/EX45(C)/EX50(C)

A plate describing how to at-
tach the implement is placed
on the standard implement of
our company.

When you are attaching an im-
plement not requiring any trac-
tion, mount the assembling
spot of the top link into the
hole A.

When you are attaching an im-
plement (like plow) requiring
some traction, mount the as-
sembling spot of the top link
into the hole B, C.

When driving with an imple-
ment attched, make sure to in-
stall the top link to the hole A
or B or put the draft control to
the “Deep” position.
H23O545A
ADJUSTMENT OF STABILIZER
(1) Telescopic Stabilizers (2) Pin
1. Adjust the telescopic stabilizers to
control horizontal sway of the im-
plement. It is also used to set the
implement on the back of the trac-
tor in center.
2. To adjust the check link, pull out
the pin and adjust it until the de-
sired transverse moving distance
is obtained.
3. Fit the pin to the gardening hole
(fixed) for normal operation and
long hole (moving) for draft work.
DRAFT HITCH AND TRAILER
(1) Draw Bar
H23O547A
The draw bar is used to pull an im-
plement, such as a trailer. This trac-
tor is equipped with a ne draw bar.
Make sure to check the max. towing
weight of the trailer and max. vertical
load that can be applied to the draw
bar.
- Max. trailer weight (trailer + load-
ed weight) = 3,500 kg (7,716 lbs)
- Vertical load of hitch (draw-bar)
= 650 kg (1,433 lbs)
CAUTION
M47-EU-06.indd 7 2012-03-15 오후 2:56:10