Daedong KIOTI EX45 - Draining Water from Clutch Housing(Al); Draining Water from Clutch Housing (Al); Wiper (Am)

7
-
35
7
-
34
MAINTENANCEEX35(C)/EX40(C)/EX45(C)/EX50(C)
7
-
35
7
-
34
MAINTENANCEEX35(C)/EX40(C)/EX45(C)/EX50(C)


    
   

(1) Wiper
H11O648A


(1) Plug

H11O647A
1. There is a plug under the clutch
housing.
2. Drain the water completely and in-
stall the plug. Drain the water into
a container and dispose of it in a
proper manner for environment
protection.
3. Make sure to install the plug and
not to damage the clutch severely.
Check the operation and wear of the
wiper blades frequently. To replace the
wiper blade, press the wiper xing le-
ver to separate it and then pull it away.
To remove the wiper arm, lift the cap of
the wiper arm, remove the nut, and set
the wiper arm upright. Then, hold the
arm head and shake it left and right to
remove the wiper arm from the drive
spindle. Disconnect the washer fluid
hose and then install a new wiper arm
to its position by aligning it to the prop-
er angle.

M47-EU-07.indd 34 2012-03-14 오후 7:19:27