15
3.4 FITTING MACHINE MODULES
Note: The software will not automatically recognise some module changes. Joysticks and motorised
tables must be initialised by re-powering the machine, or by using <Set-up> <Initialise> on
the top line menu.
3.4.1 Joysticks
Note: Any joystick may be fitted to the left or right hand side of the machine, handing conversion
may be required (see the engineers guide).
A standard configuration would have the joystick with the keypad on the right.
The fitting procedure is as follows: -
Plug in the electrical connector on the rear of the machine using the left-hand right hand labels as a guide.
Plug in the keypad at the rear of the machine.
Joystick and Keypad Leads to the
rear of the machine
To Next Page
Loading...
