63
8 CALIBRATION
Normally, your line engineer will have set-up the machine so that cartridges must be calibrated
at regular intervals.
If the calibration has expired in the range needed for the selected test group, then a warning will
be given.
It may be possible to continue to test, depending on the machine settings.
To assist good calibration, a number of calibration jigs, hooks and weights are available.
Note: - It is preferable to wait 10 minutes after fitting a cartridge before calibration.
BAD CALIBRATION MAY RESULT BY USING
INCORRECT PARTS
8.1 COLD BUMP PULL CARTRIDGE CALIBRATION
Cold Bump Pull cartridges are calibrated by using Dage designed weights and a special hook.
To calibrate, proceed as follows:
Select <Calibration> as shown below
To Next Page
Loading...
