55
7.5 BALL CLEARANCE USING A DS100KGHS
7.5.1 Tool quality
The tool tip must be sharp or what’s left of the balls may obstruct the ceramic tool tip of the
BS5KGHS during high speed testing.
Note: At the time of press the DS100KGHS in conjunction with the XY table is only rated
for 10Kg at 10mm/s. In view of this larger shear tools may not be suitable due to
excessive loading.
7.5.2 Changing a shear tool
Note: A variety of shear tool sizes are available to best suit the ball clearance procedure.
If in doubt, consult your engineer.
SHEAR TOOLS ARE SHARP AND SHOULD BE HANDLED
WITH CAUTION
SHEAR TOOLS WILL BE DAMAGED IF DROPPED
DO NOT PRESS HARD ON THE TOOL OR HOLDER
1) Loosen screw one turn (use key supplied)
2) Remove tool
3) Fit replacement tool
4) Tighten screw
To Next Page
Loading...