51
Hook mode set to Delayed.
Note: - Depending on the sample, auto-replace may not always work. It is specifically
designed for failure mode 2, as described under failure mode below.
When the test has occurred and the load
cell has reached the end of its upward
travel the cycle will stop allowing the
bond site to be inspected and graded. For
the cycle to continue the user should
ress the T button or the start icon.
2
kg
Programmable landing force
Jog
1
Programmable close time
Jaws close
3
Test starts
4
Programmable hold delay
Test complete
5
Auto replace
6
To Next Page
Loading...
