Figure 5-19 Alarm track
Step 2 Select the Enable check box to enable track linkage.
After enabling the function, manual positioning, manual tacking and auto tracking take
eect.
Step 3 Set parameters.
Table 5-3 Description of alarm track parameters
Parameter
Description
Auto Track
Select On, and the speed dome automatically links to a corresponding
position and tracks an object when the intelligent rules of the
panoramic camera trigger alarms.
Track Time
Set the alarm track time.
●
Before an object disappears: The speed dome would automatically
link to a corresponding position and tracks an object until the
object moves out of the monitoring range when the intelligent
rules of the panoramic camera trigger alarms.
●
Custom: Set the auto alarm track time of the speed dome.
Idle Time
It is an interval from the end of alarm track of the speed dome to the
start of idle mode.
Set Idle Time and Idle Position. If no event needs to be tracked after
the congured idle time, the device automatically rotates to the set
idle position. For example, the Idle Time is set to be ve seconds and
the Idle Position is set to be preset point 1. When the speed dome
does not start tracking after ve seconds, it automatically rotates to
preset 1.
To set Idle Position, rst set a preset point. For preset point, see
"4.3.2.1 Preset".
Idle Position
Step 4 Click
Save.
Operation Manual
149
To Next Page
Loading...
Need help?
General
