Figure 5-76 Vehicle density (parking upper limit)
Step 2 Click to add the vehicle density function.
Step 3 Double-click the name to modify the rule name. Select Trac Congestion or Parking
Upper Limit.
●
Trac Congestion : The system counts the vehicles in the detection area. When the
counted vehicle number and the continuous congestion time exceed the congured
values, an alarm is triggered and the system performs an alarm linkage.
●
Parking Upper Limit : The system counts the vehicles in the detection area. When the
counted vehicle number exceeds the congured value, an alarm triggered and the
system performs an alarm linkage.
Step 4 Click Draw Area to draw a detection area in the image.
Step 5 Set parameters.
Table 5-20 Description of people counting parameters
Parameter
Description
Repeat Alarm Time
After the alarm is triggered, if the status lasts for the congured
time in Repeat Alarm Time, the alarm will be triggered again.
0 indicates that the function is disabled.
Operation Manual
201
To Next Page
Loading...
Need help?
General
