Schedule to set current channel as schedule record.
System can delay the record for specified time after alarm ended.
The value ranges from 10s to 300s.
Enable alarm activation function. You need to select alarm output
port so that system can activate corresponding alarm device when
an alarm occurs.
System can delay the alarm output for specified time after an
alarm ended. The value ranges from 1s to 300s.
System can pop up a message to alarm you in the local host
screen if you enabled this function.
Check the box here to enable this function. The buzzer beeps
when an alarm occurs.
System can upload the alarm signal to the center (Including alarm
center.
When 3G network connection is OK, system can send out a
message when a video loss occurs.
If you enabled this function, System can send out an email to alert
you when an alarm occurs.
5.6.3.2 Alarm
Before operation, please make sure you have properly connected alarm devices such as
buzzer. The input mode includes local alarm, IPC offline alarm.
5.6.3.2.1 Local Alarm
From main menu->Event->Alarm->Local alarm, the local alarm interface is shown as in Figure
5-31.
Figure 5-31
To Next Page
Loading...
