264
Parameter Function
Delete
Click
, you can delete the remote connection of the
corresponding channel.
Type
There are two connection types. You can use the network to
connect to the camera or use the Wi-Fi. The means
current network camera connection mode is general; the
means current network camera mode is hotspot.
Delete
Select a device in the Added device list and then click Delete
button, system can disconnect the device and remove it from the
Added device list.
Manual Add
Click it, the interface is shown as in Figure 4-28. Here you can
add network camera manually.
You can select a channel from the dropdown list (Here only
shows disconnection channel.)
Figure 4-28
Please refer to the following sheet for parameter information.
To Next Page
Loading...
