Daikin 10 - Page 163

160
10
Miscellaneous Reference Data
Normal Normal or power failure
Alarm or power failure Alarm
60
61
63
60
61
63
60
61
63
60
61
63
Alarm and warning output logic
The alarm and warning output logic can be changed
depending on the parameter setting.
When the power supply is turned ON, external output becomes unstable.
Set up the main machine sequence program so that the external output signal is ignored for one second after
power-ON.
Value of the first digit in alarm and warning output logic parameter (n001)
0 (Factory setting) [Positive action] 1 [“b” contact]
Operation status
Power OFF
(including power failure)
Power ON
Run Run Run
Alarm
level 2
Alarm
level 1
Power supply
Remote control
contact
Operation panel
Normal (“a” contact)
Alarm/Stop (Power
OFF) (“b” contact)
Agitator operation/
Pump run (“a” contact)
Alarm level
Alarm (“a” contact)
Normal/Stop (Power
OFF) (“b” contact)
Between terminals
[60]-[63]
Between terminals
[60]-[63]
Agitator operation/
Pump run (“a” contact)
Alarm level
Between terminals
[60]-[61]
Operation
lock mode
Between terminals
[10]-[11]
Between terminals
[61]-[62]
Between terminals
[60]-[64]
Between terminals
[60]-[61]
Between terminals
[61]-[62]
Between terminals
[60]-[64]
Preset condition
Output logic parameter setting: “0”
Mode and terminal symbol of external output contact
Output logic parameter
setting: “1”
OFF
OFF
OFF
ON
ON
OFF
OFF
ON
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
ON
ON
ON
ON
ON
ONON
ON
ON
OFF
ON ON
ON
ON
ON ON ON
OFF
ON
Reset Reset
Operation status
Signal output
Normal Alarm level 2
No warning status
Output logic parameter
setting: “0”
Alarm level 1
or LOCK
Power failure
(Power OFF)
Normal Alarm level 2
Warning status
Alarm level 1
or LOCK
Power failure
(Power OFF)
Warning
output
(“a” contact)
Output logic parameter
setting: “1”
[66]-[67]
ON
OFF
ON
OFF
[66]-[67]
External output timing chart
2
3
00_PB00540A_M10.indb 160 2023/08/09 12:59:28