Daikin ECORICH EHU2504 - Page 51


51
PIM00504
Item Code Name Operation range
Default
Value
Details Reference
P50 OTUS
(Reserved for the
system)
- - This is reserved for the system. -
P51 OTAM
(Reserved for the
system)
- - This is reserved for the system. -
P52 OTAT
(Reserved for the
system)
- - This is reserved for the system. -
P53 OTWN
(Reserved for the
system)
- - This is reserved for the system. -
P54 OTWT
(Reserved for the
system)
- - This is reserved for the system. -
P55 WN_L
Motor electronic
thermal relay
overload warning
threshold value
101 - 109 [%] 105
Sets the threshold value for the
motor electronic thermal relay
overload warning.
12.6.3
Flow rate indications are displayed as shown below.
Flow Rate in the Setting Mode Display Details
Edited value .5 rounded up, .4 rounded down
Maximum value Rounded down
Minimum value Truncation + 0.1 L/min
CAUTION
The “P04: Pressure unit selection setting” is set to indication in MPa units as the factory default.
If it has been changed to indication in PSI units, implement some measure to make it apparent
that it is in PSI units, such as affixing an indication sticker. Prepare this sticker yourself. Note,
however, that using the unit in PSI units in Japan is an infringement of the Measurement Act.