72
PIM00504
13.7 Suction Strainer Maintenance Instructions
13.7.1 Removal method
1) Set a drain oil receiver below the oil drainage port, open the oil drain plug (M12 × 20L), and
drain out all of the hydraulic oil in the tank.
2) Remove the four hexagonal bolts (M8 × 20L) securing the top plate and tank, and hoist the
motor by its suspension plates to separate it from the tank.
3) This will reveal the suction strainer: loosen it with e.g. an adjustable wrench and remove it.
13.7.2 Cleaning
Air blow the filter section to blow off deposits and adhering material. Also remove dirt from inside the
strainer’s cylinder.
Hexagon head bolts
(M8 × 20L), four
Suction straine
Oil drain plug (M12 × 20L)
To Next Page
Loading...
