Danfoss FC 300 Instruction Manual

FC 300 Instruction Manual
How to Program
1-xx Load and motor parameters, including all load- and motor-related parameters
2-xx Brake parameters
• DC brake
• Dynamic brake (resistor brake)
• Mechanical brake
• Over-voltage control
3-xx References and ramping parameters includes DigiPot function
4-xx Limits and warnings; setting of limits and warning parameters
5-xx Digital inputs and outputs, including relay controls
6-xx Analog inputs and outputs
7-xx Controls; setting parameters for speed and process control
8-xx Communication and option parameters for setting of FC RS-485 and FC USB port parameters.
9-xx Profibus pa rameters
10-xx DeviceNet and CA N Fieldbus parameters
13-xx Smart Logic Control parameters
14-xx Special function parameters
15-xx Drive information parameters
16-xx Readout parameters
17-xx Encoder option parameters
*
default setting ()display text []value for use in comm unication via serial comm unication port
38
MG.33.A
6.22 - VLT is a registered Danfoss trademark

Danfoss FC 300 Specifications

General

Enclosure	IP20
Approvals	cUL, UL, CE
EMC filter	Built-in
Communication Options	CANopen, PROFIBUS DP
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overtemperature, Short Circuit
Output Voltage	0-100% of supply voltage