Danfoss FC 300 Programming Guide

Contents
1. Introduction
3
Approvals 3
Symbols 3
Abbreviations 4
Definitions 4
2. How to Programme 11
The Graphical and Numerical Local Control Panels 11
How to Programme on the Graphical LCP 11
The LCD-Display 12
Quick Transfer of Parameter Settings between Multiple Frequency Converters 14
Display Mode 16
Display Mode - Selection of Read-Outs 16
Parameter Set-Up 17
Quick Menu Key Functions 17
Main Menu Mode 20
Parameter Selection
20
Changing Data 20
Changing a Text Value 20
Changing a Group of Numeric Data Values 21
Infinitely Variable Change of Numeric Data Value 21
Changing a Data Value,Step-by-Step 22
Read-out and Programming of Indexed Parameters 22
How to Programme on the Numerical Local Control Panel 23
Local Control Keys 24
Initialisation to Default Settings 25
Parameters: Operation and Display 27
Parameters: Load and Motor 42
Parameters: Brakes 63
Parameters: Reference/Ramps 70
Parameters: Limits/Warnings 86
Parameters: Digital In/Out 94
Parameters: Analog In/Out 112
Parameters: Controllers 121
Parameters: Communications and Options 127
Parameters: Profibus 134
Parameters: DeviceNet CAN Fieldbus 145
Parameters: Smart Logic Control 153
Parameters: Special Functions 171
FC 300 Programming Guide Contents
MG.33.M2.02 - VLT
®
is a registered Danfoss trademark 1

Danfoss FC 300 Specifications

General

Enclosure	IP20
Approvals	cUL, UL, CE
EMC filter	Built-in
Communication Options	CANopen, PROFIBUS DP
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overtemperature, Short Circuit
Output Voltage	0-100% of supply voltage