2.1.15. Changing a Data Value,Step-by-Step
Certain parameters can be changed step by step or infinitely variably. This applies to
Motor Pow-
er
(par. 1-20),
Motor Voltage
(par. 1-22) and
Motor Frequency
(par. 1-23).
The parameters are changed both as a group of numeric data values and as numeric data values
infinitely variably.
2.1.16. Read-out and Programming of Indexed Parameters
Parameters are indexed when placed in a rolling stack.
Par. 15-30 to 15-32 contain a fault log which can be read out. Choose a parameter, press [OK],
and use the [▴] [▾] navigation keys to scroll through the value log.
Use par. 3-10 as another example:
Choose the parameter, press [OK], and use the [▴] [▾] navigation keys to scroll through the
indexed values. To change the parameter value, select the indexed value and press [OK]. Change
the value by using the [▴] [▾] keys. Press [OK] to accept the new setting. Press [CANCEL] to abort.
Press [Back] to leave the parameter.
2. How to Programme FC 300 Programming Guide
22
MG.33.M2.02 - VLT
®
is a registered Danfoss trademark
2
To Next Page
Loading...
